Multiple Choice
Technician A says the IAC counts should change when the A/C compressor is turned on and off. Technician B says if the scan tester indicates zero IAC counts, there may be an open circuit between the PCM and the IAC motor. Who is correct?
A) A only
B) B only
C) both A and B
D) neither A nor B
Correct Answer:

Verified
Correct Answer:
Verified
Q40: Short-term and long-term fuel trim readings are
Q41: _ and hold injector circuits use two
Q42: If the IAC counts are below 16
Q43: Technician A uses a low-impedance test light
Q44: The O<sub>2</sub> sensor should toggle between rich
Q46: Describe a speed density system.
Q47: Technician A says higher than normal idle
Q48: Which of the following components can cause
Q49: Idle learn procedures for ETC (throttle-by-wire)-equipped vehicles
Q50: An injector balance test requires an injector